SAE 2 Pin

Archive for October, 2012

Availability of SAE 2 Pin Connectors and Connector Assemblies

by on Oct.25, 2012, under Availability

In addition to providing a forum for dicussions pertinent to SAE 2 Pin Connectors, making SAE 2 Pin connectors and assemblies readily available with a range of wire sizes at economical prices is our mission.

This website was created to be even more specific to the SAE 2 Pin Connector – rather than it’s application.  It was created to supplement our initial websites:  www.bohemianbiker.com and www.solarcapitalist.com

For those wishing to procure SAE 2 Pin connector assemblies in quantity, we strongly suggest calling us at 302-562-1706, or emailing us at sae2pinray@sae2pincom

Calling or emailing will allow us the opportunity to address your needs/desires specifically.

We have a very large inventory of the 16 AWG SAE 2 Pin Extension (12″) Assembly most widely available on a retail basis – in bulk form (i.e., not coiled up in individual packaging).

 

Often not immediately recognized – this 12″ extension can be cut in half (into 2 connector “pigtails”) to provide a”junction” when the plugs are connected, i.e., the red “hot” lead mapped to the exposed “male” pin on one connector (“load” side) mates up with the protected “female” socket side of the other (“power” side) connector pigtail.  We make this differentiation between “Load” side and “Power” side because as a matter of safe practice – Red insulation indicating “Hot” (+) Positive by standard would lead to the protected “female” socket side on the “power source” side (for example, battery side) of the Junction.

These handy, inexpensive SAE 2 Pin assemblies are often used to provide a circuit disconnection point in a convenient location – most often in 12 volt lighting and accessory circuit systems.

Where the quality associated with offshore mass production is adequate, these assemblies might be your choice – for applications in which higher quality assemblies produced here in the USA would be best, we can certainly meet those requirements, as well !!!

Again – we strongly recommend calling us at 302-562-1706, or emailing us at sae2pinray@sae2pin.com

We are well prepared to address your SAE 2 Pin connector assembly needs !!!

 

Leave a Comment :, , more...

Looking for something?

Use the form below to search the site:

Still not finding what you're looking for? Drop a comment on a post or contact us so we can take care of it!

Visit our friends!

A few highly recommended friends...